There are many ways of using bookbinding machines, which vary from person to person. The way of use of everyone will be different. Here is a specific introduction.
The first step is to punch holes. The general bookbinding machine has a ruler to adjust the left and right position on this basis, and there is a single board that can adjust the distance between the front and back. Generally, the margin is about 2.5CM. The manual machine can be adjusted through the knob behind the machine. The automatic machine can adjust the joints through the two knobs on the side, and the hole can be perforated after the good position. The next second step is manual hot riveting. After finishing the hole, the general rivet pipe will be automatically cut and fell into the slot. Just put the cut rivet into the hole, move to the left rivet on the left, insert the centering shaft into the riveting pipe and press down the handle, and the pressure is only 2 to 3 seconds.